Diamond file

Round Diamond Files. Good for filing holes and concave surfaces. Triangular Diamond Files. Point Diamond Files. Square Diamond Files. Half-Round Diamond Files. Thin-Face Electrical Contact Files. Diamond Needle Files. Flexible Diamond Needle Files. Diamond Needle File Sets. Smoothing and Polishing Stones. Hand-Held Diamond Sharpening Stones. Bench Diamond Sharpening Stones. Knife Edge-Straightening and Sharpening Steels. The quick brown fox jumped over the lazy dog. Pedestal 35" Ht.

Half Round. Aluminum Oxide. Carbon Fiber. Hardened Steel. Tool Steel. Extra Fine. Buses Paradero Buses Sin Nomenclat. Hogar I. CD CD A CX You must be logged in to post a comment. Leave a Reply Cancel reply You must be logged in to post a comment. Even when you have a round or half round file, they still only cut in a forward direction. They don't work sideways or in a circular motion, for example.

In contrast diamond files don't actually have teeth as such, but diamond grit. This gives diamond files the unique property in that they will work in any direction. The distribution of diamond particles enables the diamond needle file to not only cut in all directions but also produce a much better finish.

Therefore diamond needle files can offer a fantastic abrasive for a variety of applications. Due to the hardness of diamond, diamond files can be used on a variety of materials that other abrasives will not have an impact upon.

When you're working in small intricate areas the diamond file will work on the pull stroke just as effectively as it does on the push stroke. So this may make it slightly easier in confined spaces. It also means in theory that it will cut twice as fast as a toothed file of the same grit because it's cutting on the pull as well as on the push stroke.

You can use the fine tiny points of the files to get into tiny areas. As long as you can move the file in any direction, it will cut and it will file for you.

This is particularly useful with a large round grit diamond file as it can be rotated inside a hole or outside a ring, and it will cut in degrees. Great for the inside of ring shanks and also for deep burring. A large half round grit file is also great for the inside of rings and bangles and it has a nice wide flat profile so that can be used on the outside of rings without changing files.

A great companion to the round file. Over time tungsten carbide cutting tools will dull and it is often easier to have a hand tool abrasive that you can take straight to the cutting tool, rather than having to take a cutting tool to an electric grinding wheel. A round diamond needle file can be used for opening up a huge array of holes in hardened surfaces, grit being the most common for most applications. Small screw holes in watches and clocks to holes in jewels and beads can all be opened up with a round diamond file.

Choose diamond files that are either or grit for the best results. If you solder a post onto the back of an earring, for example, a square grit diamond file will help you get right into that solid joint and clean up both the horizontal and vertical surfaces. It also has a very nice sharp point. A round diamond file can be used for removing excessive solder inside a ring band and the finish is finer than what you would achieve with a traditional ring file.

Sometimes when fitting watch or clock crystals the sizes need to be altered slightly, the use of a grit diamond needle file will produce the required result in minimal time. Clock and watch pallets are very hard and become burred and mis-shapen over time.

The use of a grit fine diamond file can radically change the surface of the pallet for a more efficient movement.